Skip to content

How it works ​

This page describes how RC2FX runs on the mixer. The architecture page has the technical detail.

The audio engine ​

The RØDECaster Pro II contains a four-core ARM processor running Linux. All of its audio passes through RØDE's audio engine, which processes a block of audio every 2.3 ms, about 430 times per second.

RC2FX is a library that the audio engine loads at startup. In each 2.3 ms block it runs the effects on the channels you have enabled and leaves the other channels untouched. Because it runs inside the engine, it adds no extra audio connections and has no fixed limit on how many channels it can process.

Noise suppression takes longer than 2.3 ms per block, so it runs on its own core a few blocks behind the engine. That is the source of its delay.

How RC2FX is loaded ​

The installer starts from RØDE's official firmware release and checks that it is a version RC2FX supports. It then adds three things: RC2FX itself, your settings, and a small launcher. RØDE's system starts the audio engine by name, and the launcher is found first under that name, so the engine starts with RC2FX loaded. A second launcher does the same for the screen program, which is how screen conversion works. RØDE's own programs are left unmodified.

At startup RC2FX compares the audio engine byte for byte with the builds it has been tested against. If there is no match, it doesn't load, and the mixer runs stock firmware behaviour.

Falling back to stock ​

RC2FX switches itself off for the rest of the session, leaving the mixer running as stock, if any of these happen:

  • its control program stops
  • the mixer doesn't finish starting within a minute
  • the mixer stops unexpectedly twice in one session

Power-cycling the mixer gives RC2FX another try.

RC2FX doesn't run during the first start after a firmware update. The mixer uses that start to update its internal controllers.

Settings storage ​

Settings and presets are stored on the mixer. When you press Save to mixer, the app sends the settings over USB. RC2FX validates them, saves them, and switches to them between two audio blocks, so there is no gap or restart. The app only needs to be open while you are changing settings.

USB control ​

The app talks to the mixer over USB 1, the same connection RØDE's app uses. That connection has a control channel for RØDE's app, and RC2FX sends its own messages on it in a form RØDE's software ignores. It needs no network, IP address or extra drivers, and USB audio is unaffected.

Installing by flashing firmware ​

The installer adds RC2FX during a firmware update. At that point nothing is running, and RØDE's updater writes the files. The installer prepares a modified copy of the firmware on your computer, and the mixer installs it through its normal update mode. If the update fails before the final step, switching the mixer off for 30 seconds restores the previous firmware.